|Device has been set to return to the scheduled weekly rules.
|User presented a credential that has been accepted.
|An admit has been sent from a dashboard widget.
|An access point was set to an unlocked state from the dashboard.
|An auto-unlock schedule has started.
|An Auto-Unlock w/ Badge rule has started.
|Decline Credential Not Found
|Presented credential has not been accepted (ensure the weekly rules have been configured properly)
|Decline Outside Schedule
|Presented credential has access to this reader but not at the time the credential was read (too early or too late, see the current rule’s schedule).
|A credential is declined because there is a tamper alert.
|The device has connected to the software.
|The device has lost connection to the software.
|New/Updated information has been sent to all access points.
|New/Updated information has been sent to all connected access points.
|Some or all information was not able to reach the reader.
|Credential Sent to Reader
|The user is configured for access in the software, but an update had not been pushed/received so the credential has been sent to the reader as a partial compile.
|A lockdown of access points has been activated.
|Reader has been set back to the current schedule and is no longer locked down.
|Credential has been declined because access point is currently locked down.
|There was a REX event on the device, unlocking the door unless set to “REX w/o Unlatch.”
|AUX admit occurred from an input button tied into the device.
|Command sent to reader unrelated to active process.
|Hardware error (the Coldfire and Coprocessor firmware may be mismatched). Please contact support if this persists.
|Hardware error. Please contact support if this persists.
|The virtual device has been deactivated.
Thanks for your feedback.