Configuring an Access Point

Configure Now

When selecting Configure Now (within the Create Access Point wizard), you will be immediately directed to a new dialog box where you can configure the access point and then run through tests. These options will vary depending on the device type. Here are the default configuration settings for each:

• RC-04
  
• RC-03
  
• IP-Bridge
  

Configure Later

To modify the configuration settings on a device:

1. Navigate to the Access Points page
2. Select next to the Access Point you wish to configure, then choose Edit Device Settings
3. Make the desired changes, then:
   1. You may select to jump ahead to the last page of the wizard
   2. Or you may select to proceed with testing the enabled peripherals
4. Follow the prompts, then click when finished