Configuring Keypad Site Code on an R-1 Reader

1. Power cycle the R-1 reader.
2. Within one minute from powering on the unit, enter: 8 8 8 8 9 9 9 9
   The LED will turn green and the keypad will beep three times.
3. Within five seconds, enter # followed by any three-digit facility code: _ _ _
   The LED will turn green and the keypad will beep three times.

In this mode, the reader sends the PIN (packaged as a 26-bit Wiegand output with the fixed facility code). We recommend PIN numbers to be at least four-digits long between 1 and 32767.

The PIN should always be entered starting with and ending with .

*Most sites will not have a site code already established. If no site code had ever been set, we recommend 0 0 1.