Another way to configure devices is to use the configuration tool to scan an IP address or range of addresses.

Adding a device by IP

Simply select Add Device by IP, then select the Scan IP Range check box. Enter the start address and the last octet of the end address and select add device.

Add Devices by IP range

From here you simply select the units that are discovered by selecting the check box or select all discovered devices and configure them to the appropriate URL.

For more information on how to set up your access points, check out our YouTube channel for further details.

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.