There are multiple commands that can be sent to readers from the App Bar. A Compile command will need to be sent to your devices when changes are made to users, rules, or access points.
An Admit, Lock Down, Schedule, or Unlocked command can be sent to individual access points, access point groups, or all devices by selecting then “Commands.” See below for more information.
Sending a Compile
When a change that requires a compile is made, the send command button will display a red notification badge.
- Click
from the App Bar
- Select Compile
- (optional) Verify compile was sent successfully using a History widget or report
Sending a compile requires that the web access user has one (or more) of the following permissions:
- User Details Modify
- User Groups Modify
- Access Points Modify
- Access Point Groups Modify
- Weekly Rules Modify
- Holidays & Events Modify
Sending Additional Commands
- Click
from the App Bar
- Select Commands
- Select the access point(s) you would like to send a command to, then choose the action:
- Admit: unlocks the access point or access point group for the latch interval set per device
- Lock Down: locks down the access point or access point group. While in Lock Down mode, access is denied to all users except those whose credentials include the Pass-Through special property.
- Schedule: places access point into a normal state (following the configured weekly rules)
- Unlocked: unlocks the access point or access point group
- Lock: overrides an Auto Unlock Weekly Rule or Event, returning the access point or access point group to a locked state (Engage devices only)
- Clear Tamper: clears a tamper alarm on an access point (Engage devices only)
Sending command via the App Bar requires that the web access user has one (or more) of the following permissions:
- Access Points Modify
- Access Point Groups Modify
- Weekly Rules Modify
- Holidays & Events Modify
Last modified:
13 March 2026



from the App Bar