Pure Access Product Manual

Adding a Reader Controller (legacy device)

  1. Navigate to the Access Points page
  2. Hover over the speed dial button and then select Create Access Point
    1. For a device that is plugged in and discoverable on the network:
      1. Select “Yes” to the question “Is your device ready to connect?”
      2. Input the MAC address of the reader controller (located on the back and side of the device)
      3. If the device is either not configured properly or is not currently discoverable, the following message will be displayed:
    2. For a device that is either not plugged in or not currently discoverable on the network:
      1. Select “No” to the question “Is your device ready to connect?”
      2. Input the MAC address of the reader controller (located on the back and side of the device)
      3. Choose the device type from the drop-down list (this may auto-populate with the correct type)
    3. Input a name for the access point
    4. Input a description (optional)
    5. Select the relevant access point group(s) from the list (optional)
    6. Choose the Area to which this access point belongs (if applicable)
    7. Select either “Configure Later” or “Configure Now”

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.